The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

105 SALOON PARTS : OTHER FUEL SYSTEM PARTS

  • FL026/1 FUEL HOSE CLIP 12-14 mm

    Replacement fuel hose clip to suit all Alfa fuel lines (usually 7mm internal diameter).

    $0.49
  • FL036 CHOKE CABLE - DASH MOUNTED

    Replacement choke cable for all GTs/GTVs, Saloons and Spiders that have the choke lever mounted on the dashboard. Not suitable for 1750 2000 Spiders that have the choke mounted on the centre console. See FL025 for that part.

    $6.56
  • FL005 FUEL FILTER ELEMENT - SMALL

    Fuel filter element small - Fispa type fits in small glass bowl as used on most Alfas from late 1950s until 1975. Includes spring. 4 cm long/tall and 3.3 cm diameter. For the seal between glass bowl and unit order FL078.

    $5.46
  • FL006 FUEL FILTER ELEMENT - LARGE (FILTER KING)

    Fuel filter element - larger size, fits into the metal housing found on some later carburettor cars (1975 to 1986) as well as the replacement filter king fuel filter unit available under code FL053. Size 4cm tall/long by 4 cm diameter.

    $5.46
  • FL078 RUBBER SEAL FOR FISPA FILTER UNIT

    Rubber seal to fit into the original engine bay Fispa fuel filter/pressure regulator unit fitted to 750, 101 and 105 Series cars. This filter unit uses the smaller 3.3cm diameter filter FL005. Dimensions, outside diameter 53mm,and inside diameter 41mm.

    $4.80
  • FL022 INLET MANIFOLD GASKET - ALL CARB & SPICA 105…

    Inlet manifold gasket to fit all twin carburettor 105 series cars and Spica equipped models. For early single carburettor cars see code FL022/1 and for later Fuel Injected cars see FL039.

    $6.37
  • FL050 METAL THROTTLE ROD END

    Metal throttle rod end - use with new adjustable throttle rod - 2 required per rod

    $3.34
  • FL051/1 SHORT VERTICAL THROTTLE ROD - 45mm

    Short vertical throttle rod (central aduster threaded rod is 45mm) that fits between the carburettors on twin carburettor 101 and 105 series cars. Includes metal ends and spring retaining clips. Note that this will fit right hand...

    $18.15
  • FL051/2 VERTICAL THROTTLE ROD - 97mm

    Short vertical throttle rod (approx 97mm between centres) that fits between the carburettors on some Left Hand Drive 1750 and 2000 model 105 Series cars - and possibly some other versions too. Includes metal ends and spring retaining clips. Note that RHD...

    $19.36
  • FL051 ADJUSTABLE MAIN THROTTLE ROD

    Adjustable throttle rod. Replace your old worn out horizontal plastic rod and make sure you are getting full throttle travel! Vertical rod also available - see item code FL051/1 Metal ends available separately under code FL050.

    $20.58
  • FL024 SCHLEYER CARBURETTOR AIRFLOW TESTER/SYNCHROM…

    Schleyer carburettor airflow tester/synchrometer - used to check the airflow through each carburettor to assist you in balance the flow across multiple carburettors. Use in conjunction with the adaptor elbow under available under item code...

    $45.53
  • FL033 HOT AIR DUCTING TUBE - AIR INTAKE

    Hot air ducting tube (60mm diameter) to suit all 105 series cars from 1970 on with the 'warm air' intake panel located on the side of the engine block. This tube goes from the air cleaner to the plate.

    $10.62
  • FL076 PAIR OF SPICA INJECTION AIR FILTERS

    Pair of air filters to fit the intake system of US specification SPICA mechanical fuel injection 4 cylinder cars. Filters approx 185mm long and 90mm diameter each.

    $36.42

Follow Us @classicalfaltd